This is an old revision of the document!
Lantian L90
Specifications |
Frame | Lantian L90 |
FC | F3 V2 RacerCube w/ BEC & LC Filter & OSD (from MyRCMart) |
ESC | BLHELI_S V2 10A 4in1 ESC (from MyRCMart) |
Motors | Racerstar Racing Edition 1103 BR1103B 8000KV |
Props | Kingkong 1935 3-Blade Bullnose |
Receiver | FS-RX2A Pro |
Camera | 600TVL 1/4 1.8mm CMOS FPV 170 Degree Wide Angle Lens (from Banggood) |
VTX | Eachine VTX03 |
Battery | Turnigy nano-tech 2S1P 460 mAh 25-40C |
|
Weight | 57 g
88 g (with 2S1P 460 mAh battery) |
M2M | 9 cm |
Flight time | 4-5 minutes |
Notes
Edges of frame pieces should be sanded to avoid wear in wiring
Camera has been mounted with rubber O-rings due to lack of better mount
Receiver antenna has been reinforced with cable tie + heat shrink
Don't attempt to flash the ESC firmware, 1 of 4 is likely to fail if done via FC, however changing settings is ok
The camera isn't too bad in adjusting to illumination changes but a RunCam Micro Swift 2 should also fit (not tested)
Remove the microphone from the camera, you don't need it
Replace nylon standoffs with aluminium standoffs for extra durability
Wiring
Don't mix V1 and V2 FC and ESC board, the connecting wires have different outputs
The battery wires are on the bottom of the ESC board so be extra careful not to let plain wires touch the frame