This is an old revision of the document!

RCX H130CF

Specifications
Frame	RCX H130CF
FC	F3 V1 RacerCube w/ BEC & LC Filter & OSD (from MyRCMart)
ESC	BLHELI_S V1 10A 4in1 ESC (from MyRCMart)
Motors	RCX H1407 3200KV
Props	HQProp 3x3x3
Receiver	FS-RX2A Pro
Camera	RunCam Swift Mini with 2.5 mm lens
VTX	TBS Unify Pro HV Race
Antenna	Foxeer 5.8G RHCP, short
Battery	Tattu 4S 650 mAh 75C

Weight	around 250 g with battery
M2M	13 cm
Flight time	3-5 minutes

Videos

Edges of frame pieces should be sanded to avoid wear in wiring
Don't attempt to flash the ESC firmware, 1 of 4 is likely to fail if done via FC, however changing settings is ok

Don't mix V1 and V2 FC and ESC board, the connecting wires have different outputs
- V2 is much less messy to use and it doesn't require a separate battery wiring to FC
The battery wires are on the bottom of the ESC board so be extra careful not to let plain wires touch the frame
- Use a piece of electric tape just to be on the safe side