rc:diy-h-frame-fpv-quadcopter
This is an old revision of the document!
DIY H-Frame FPV Quadcopter
| Specifications | |
|---|---|
| Frame | DIY |
| FC | Naze32 (full), rev 5 |
| Motor | T-Motor MT2206-23 1200KV x 4 |
| ESC | Bull Tec 12A ESC (with simonk) x 4 |
| Prop | GemFan 8x4.5 x 4 |
| Receiver | FrSky TFR4 |
| Camera | CM-YN3130CH (PAL) with 2.8mm lens |
| VTX | ImmersionRC 5.8 GHz 25 mW |
| Antenna | Circular Polarized |
| OSD | minimOSD with multiwiiosd |
| Battery | Turnigy nano-tech 3S1P 2200 mAh |
| M2M | 35 cm |
Notes
- This frame ended up not getting much use as Blackout Super Mini H Quad was suitable also for cruising and had a better form factor
- Outdated and heavy design
- Battery too small, 4S would likely have been more suitable
- Lack of BEC causes one ESC to heat up far too much
- Long frame causes too easily shadows for signals
rc/diy-h-frame-fpv-quadcopter.1465737090.txt.gz · Last modified: 12.06.2016 16:11 by vergo
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
