User Tools

Site Tools


rc:turnigy-bonsai

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
rc:turnigy-bonsai [28.07.2016 02:23]
vergo
rc:turnigy-bonsai [28.07.2016 02:24] (current)
vergo
Line 16: Line 16:
 ===== Notes ===== ===== Notes =====
  
-  ​the carbon rods + z bend pieces don't stay well together using only heatshrink +  ​the carbon rods + z bend pieces don't stay well together using only heatshrink 
-  ​heavier than suggested battery was needed for achieving correct center of gravity +  ​heavier than suggested battery was needed for achieving correct center of gravity 
-  ​the servos stays well in place even without glue +  ​the servos stays well in place even without glue 
-  ​battery and receiver compartments are too small by default +  ​battery and receiver compartments are too small by default 
-  ​hot glue was used during assembly instead of CA +  ​hot glue was used during assembly instead of CA 
-  ​HobbyKing ESC replaced with HobbyWing ESC on 28.7.2016 to get break support+  ​HobbyKing ESC replaced with HobbyWing ESC on 28.7.2016 to get break support
rc/turnigy-bonsai.txt · Last modified: 28.07.2016 02:24 by vergo