rc:turnigy-bonsai
Turnigy Bonsai
| Specifications | |
|---|---|
| Motor | T-Motor MT1306 3100KV |
| ESC | HobbyWing FlyFun 10A |
| Servos | 2 x Hextronik HXT500 |
| Prop | GemFan 5x3 |
| Receiver | FrSky TFR4-B |
| Battery | Turnigy nano-tech 2S1P 950 mAh |
| Weight | 145 g (with battery) |
| Flight time | 6-10 minutes |
Notes
- the carbon rods + z bend pieces don't stay well together using only heatshrink
- heavier than suggested battery was needed for achieving correct center of gravity
- the servos stays well in place even without glue
- battery and receiver compartments are too small by default
- hot glue was used during assembly instead of CA
- HobbyKing ESC replaced with HobbyWing ESC on 28.7.2016 to get break support
rc/turnigy-bonsai.txt · Last modified: 28.07.2016 02:24 by vergo
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
