Differences
This shows you the differences between two versions of the page.
Both sides previous revision
Previous revision
|
|
rc:turnigy-bonsai [28.07.2016 02:23] vergo |
rc:turnigy-bonsai [28.07.2016 02:24] (current) vergo |
===== Notes ===== | ===== Notes ===== |
| |
- the carbon rods + z bend pieces don't stay well together using only heatshrink | * the carbon rods + z bend pieces don't stay well together using only heatshrink |
- heavier than suggested battery was needed for achieving correct center of gravity | * heavier than suggested battery was needed for achieving correct center of gravity |
- the servos stays well in place even without glue | * the servos stays well in place even without glue |
- battery and receiver compartments are too small by default | * battery and receiver compartments are too small by default |
- hot glue was used during assembly instead of CA | * hot glue was used during assembly instead of CA |
- HobbyKing ESC replaced with HobbyWing ESC on 28.7.2016 to get break support | * HobbyKing ESC replaced with HobbyWing ESC on 28.7.2016 to get break support |