rc:rcx-h130cf
Differences
This shows you the differences between two versions of the page.
| Next revision | Previous revision | ||
|
rc:rcx-h130cf [02.07.2018 22:16] vergo created |
rc:rcx-h130cf [29.07.2024 01:19] (current) vergo |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ~~NOTOC~~ | ~~NOTOC~~ | ||
| + | |||
| + | <note important> | ||
| ====== RCX H130CF ====== | ====== RCX H130CF ====== | ||
| - | {{ : | + | {{ : |
| ^ Specifications | ^ Specifications | ||
| | Frame | RCX H130CF | | | Frame | RCX H130CF | | ||
| - | | FC | F3 V1 RacerCube w/ BEC & LC Filter & OSD (from MyRCMart) | | + | | FC | F3 V1 RacerCube w/ <del>BEC</ |
| + | | BEC | 5V 2A external | ||
| | ESC | BLHELI_S V1 10A 4in1 ESC (from MyRCMart) | | | ESC | BLHELI_S V1 10A 4in1 ESC (from MyRCMart) | | ||
| | Motors | RCX H1407 3200KV | | | Motors | RCX H1407 3200KV | | ||
| | Props | HQProp 3x3x3 | | | Props | HQProp 3x3x3 | | ||
| - | | Receiver | FS-RX2A Pro | | + | | Receiver | <del>FS-RX2A Pro</ |
| - | | Camera | RunCam Swift Mini with 2.5 mm lens | | + | | Camera | <del>RunCam Swift Mini with 2.5 mm lens</ |
| - | | VTX | TBS Unify Pro HV Race | | + | | VTX | <del>TBS Unify Pro HV Race</ |
| - | | Antenna | Foxeer 5.8G RHCP, short | | + | | Antenna | <del>Foxeer 5.8G RHCP, short</ |
| | Battery | Tattu 4S 650 mAh 75C | | | Battery | Tattu 4S 650 mAh 75C | | ||
| ^ ^^ | ^ ^^ | ||
| - | | Weight | around 250 g with battery | | + | | Weight | < |
| | M2M | 13 cm | | | M2M | 13 cm | | ||
| | Flight time | 3-5 minutes | | | Flight time | 3-5 minutes | | ||
| Line 23: | Line 26: | ||
| ===== Videos ===== | ===== Videos ===== | ||
| - | * https:// | + | |
| + | * https:// | ||
| + | | ||
| ===== Notes ===== | ===== Notes ===== | ||
| Line 29: | Line 34: | ||
| - Edges of frame pieces should be sanded to avoid wear in wiring | - Edges of frame pieces should be sanded to avoid wear in wiring | ||
| - Don't attempt to flash the ESC firmware, 1 of 4 is likely to fail if done via FC, however changing settings is ok | - Don't attempt to flash the ESC firmware, 1 of 4 is likely to fail if done via FC, however changing settings is ok | ||
| + | - Motor KV is too low for 3S batteries, can be flown but feels underpowered | ||
| + | - OSD chip is including severe noise to video when going past 3S, caps and filters don't help, removing BEC from FC and using external BEC solved the issue | ||
| ===== Wiring ===== | ===== Wiring ===== | ||
rc/rcx-h130cf.1530558989.txt.gz · Last modified: 02.07.2018 22:16 by vergo
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
