This is an old revision of the document!

Lantian L90

Specifications
Frame	Lantian L90
FC	F3 V2 RacerCube w/ BEC & LC Filter & OSD (from MyRCMart)
ESC	BLHELI_S V2 10A 4in1 ESC (from MyRCMart)
Motors	Racerstar Racing Edition 1103 BR1103B 8000KV
Props	Kingkong 1935 3-Blade Bullnose
Receiver	FS-RX2A Pro
Camera	600TVL 1/4 1.8mm CMOS FPV 170 Degree Wide Angle Lens (from Banggood)
VTX	Eachine VTX03
Battery	Turnigy nano-tech 2S1P 460 mAh 25-40C

Weight	57 g 88 g (with 2S1P 460 mAh battery)
M2M	9 cm
Flight time	4-5 minutes

Notes

Edges of frame pieces should be sanded to avoid wear in wiring
Camera has been mounted with rubber O-rings due to lack of better mount
Receiver antenna has been reinforced with cable tie + heat shrink
Don't attempt to flash the ESC firmware, 1 of 4 is likely to fail if done via FC, however changing settings is ok
The camera isn't too bad in adjusting to illumination changes but a RunCam Micro Swift 2 should also fit (not tested)
Remove the microphone from the camera, you don't need it
Replace nylon standoffs with aluminium standoffs for extra durability
- The provided M2 screws are however good and long enough

Don't mix V1 and V2 FC and ESC board, the connecting wires have different outputs
- V2 is much less messy to use and it doesn't require a separate battery wiring to FC
The battery wires are on the bottom of the board so be extra careful not to let plain wires touch the frame
- Use a piece of electric tape just to be on the safe side