This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
rc:realacc-martian-iv-3-inch [25.04.2021 21:09] vergo |
rc:realacc-martian-iv-3-inch [13.05.2021 01:51] vergo [Wiring] |
||
---|---|---|---|
Line 8: | Line 8: | ||
| Motors | RCX H1304 5000KV | | | Motors | RCX H1304 5000KV | | ||
| Props | < | | Props | < | ||
- | | Receiver | < | + | | Receiver | < |
| Camera | RunCam Robin with 1.8 mm lens | | | Camera | RunCam Robin with 1.8 mm lens | | ||
| DVR | RunCam Mini FPV DVR Module | | | DVR | RunCam Mini FPV DVR Module | | ||
Line 52: | Line 52: | ||
===== Wiring ===== | ===== Wiring ===== | ||
- | {{: | + | {{: |
* BB from FC connector (white wire) is for buzzer | * BB from FC connector (white wire) is for buzzer | ||
* S6 from FC connector (yellow wire) is DVR control | * S6 from FC connector (yellow wire) is DVR control | ||
- | * TX6 from FC is used for VTX SmartAudio | + | * TX3 from FC is used for VTX SmartAudio |
+ | * TX6 from FC is used for the receiver | ||
* Dual ground wiring in DVR is needed to reduce signal noise | * Dual ground wiring in DVR is needed to reduce signal noise | ||
* The FC connector is in reality in the top end of the FC but has been marked in the image on the side for clarity, unused wires can be removed | * The FC connector is in reality in the top end of the FC but has been marked in the image on the side for clarity, unused wires can be removed | ||
* The shown wiring result in the OSD being visible in the video recorded by the DVR | * The shown wiring result in the OSD being visible in the video recorded by the DVR | ||