This is an old revision of the document!

RCX H130CF

Specifications
Frame	RCX H130CF
FC	F3 V1 RacerCube w/ ~~BEC~~ & LC Filter & OSD (from MyRCMart)
BEC	5V 2A external
ESC	BLHELI_S V1 10A 4in1 ESC (from MyRCMart)
Motors	RCX H1407 3200KV
Props	HQProp 3x3x3
Receiver	~~FS-RX2A Pro~~ FrSky R-XSR
Camera	~~RunCam Swift Mini with 2.5 mm lens~~ RunCam Split Mini
VTX	~~TBS Unify Pro HV Race~~ Eachine VTX03
Antenna	~~Foxeer 5.8G RHCP, short~~ Realacc UXII Stubby RHCP antenna
Battery	Tattu 4S 650 mAh 75C

Weight	~~183 g~~ 166 g ~~252 g~~ 235 g (with 4S 650 mAh battery)
M2M	13 cm
Flight time	3-5 minutes

Videos

Edges of frame pieces should be sanded to avoid wear in wiring
Don't attempt to flash the ESC firmware, 1 of 4 is likely to fail if done via FC, however changing settings is ok
Motor KV is too low for 3S batteries, can be flown but feels underpowered
OSD chip is including severe noise to video when going past 3S, caps and filters don't help, removing BEC from FC and using external BEC solved the issue

Don't mix V1 and V2 FC and ESC board, the connecting wires have different outputs
- V2 is much less messy to use and it doesn't require a separate battery wiring to FC
The battery wires are on the bottom of the ESC board so be extra careful not to let plain wires touch the frame
- Use a piece of electric tape just to be on the safe side