This is an old revision of the document!
RCX H130CF
Specifications |
Frame | RCX H130CF |
FC | F3 V1 RacerCube w/ BEC & LC Filter & OSD (from MyRCMart) |
ESC | BLHELI_S V1 10A 4in1 ESC (from MyRCMart) |
Motors | RCX H1407 3200KV |
Props | HQProp 3x3x3 |
Receiver | FS-RX2A Pro |
Camera | RunCam Swift Mini with 2.5 mm lens |
VTX | TBS Unify Pro HV Race |
Antenna | Foxeer 5.8G RHCP, short |
Battery | Tattu 4S 650 mAh 75C |
|
Weight | around 250 g with battery |
M2M | 13 cm |
Flight time | 3-5 minutes |
Videos
Notes
Edges of frame pieces should be sanded to avoid wear in wiring
Don't attempt to flash the ESC firmware, 1 of 4 is likely to fail if done via FC, however changing settings is ok
Motor KV is too low for 3S batteries, can be flown but feels underpowered
Wiring
Don't mix V1 and V2 FC and ESC board, the connecting wires have different outputs
The battery wires are on the bottom of the ESC board so be extra careful not to let plain wires touch the frame