User Tools

Site Tools


rc:lantian-l90

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
rc:lantian-l90 [05.05.2019 22:03]
vergo
rc:lantian-l90 [01.06.2019 20:12] (current)
vergo
Line 1: Line 1:
 ~~NOTOC~~ ~~NOTOC~~
 +
 +<​note>​Below image has old camera, vtx antenna and receiver antenna setup.</​note>​
  
 ====== Lantian L90 ====== ====== Lantian L90 ======
Line 11: Line 13:
 | Motors | Racerstar Racing Edition 1103 BR1103B 8000KV | | Motors | Racerstar Racing Edition 1103 BR1103B 8000KV |
 | Props | Kingkong 1935 3-Blade Bullnose | | Props | Kingkong 1935 3-Blade Bullnose |
-| Receiver | <​del>​FS-RX2A Pro</​del>​\\ FrSky XM |+| Receiver | <​del>​FS-RX2A Pro</​del>​\\ ​<del>FrSky XM</​del>​\\ FrSky XM+ |
 | Camera | <​del>​600TVL 1/4 1.8mm CMOS FPV 170 Degree Wide Angle Lens (from Banggood)</​del>​\\ RunCam Micro Swift 2 with 2.1 mm lens | | Camera | <​del>​600TVL 1/4 1.8mm CMOS FPV 170 Degree Wide Angle Lens (from Banggood)</​del>​\\ RunCam Micro Swift 2 with 2.1 mm lens |
 | VTX | Eachine VTX03 | | VTX | Eachine VTX03 |
Line 33: Line 35:
  
   - Edges of frame pieces should be sanded to avoid wear in wiring   - Edges of frame pieces should be sanded to avoid wear in wiring
-  - Camera has been mounted with rubber O-rings due to lack of better mount+  - <del>Camera has been mounted with rubber O-rings due to lack of better mount</​del>​
   - Receiver antenna has been reinforced with a cable tie + heat shrink   - Receiver antenna has been reinforced with a cable tie + heat shrink
   - Don't attempt to flash the ESC firmware, 1 of 4 is likely to fail if done via FC, however changing settings is ok   - Don't attempt to flash the ESC firmware, 1 of 4 is likely to fail if done via FC, however changing settings is ok
Line 45: Line 47:
     * With some plastic removal, it's possible to fit the camera using a custom mount while still using the default standoffs and having possibility to get some angle to the camera     * With some plastic removal, it's possible to fit the camera using a custom mount while still using the default standoffs and having possibility to get some angle to the camera
     * Only the height is a restricting factor     * Only the height is a restricting factor
 +  - FrSky XM replaced with FrSky XM+ due to [[https://​www.youtube.com/​watch?​v=-iHfjfsTRsQ|random poor range issues]]
  
 ===== Wiring ===== ===== Wiring =====
rc/lantian-l90.txt ยท Last modified: 01.06.2019 20:12 by vergo