This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
rc:diy-h-frame-fpv-quadcopter [19.03.2015 23:29] vergo |
rc:diy-h-frame-fpv-quadcopter [19.06.2016 13:16] (current) vergo |
||
---|---|---|---|
Line 1: | Line 1: | ||
~~NOTOC~~ | ~~NOTOC~~ | ||
+ | |||
+ | <note important> | ||
====== DIY H-Frame FPV Quadcopter ====== | ====== DIY H-Frame FPV Quadcopter ====== | ||
- | {{ : | + | {{ : |
^ Specifications | ^ Specifications | ||
- | | Frame | DIY | | + | | Frame | DIY (Plywood frame + square aluminium arms) | |
| FC | Naze32 (full), rev 5 | | | FC | Naze32 (full), rev 5 | | ||
| Motor | T-Motor MT2206-23 1200KV x 4 | | | Motor | T-Motor MT2206-23 1200KV x 4 | | ||
Line 18: | Line 20: | ||
| Battery | Turnigy nano-tech 3S1P 2200 mAh | | | Battery | Turnigy nano-tech 3S1P 2200 mAh | | ||
^ ^^ | ^ ^^ | ||
+ | | Weight | 530 g\\ 710 g (with battery)\\ 750 g (with battery & mobius) | | ||
| M2M | 35 cm | | | M2M | 35 cm | | ||
+ | | Flight time | around 6 minutes | | ||
+ | |||
+ | ===== Notes ===== | ||
+ | |||
+ | * This frame ended up not getting much use as [[rc: | ||
+ | * Outdated and heavy design | ||
+ | * Bigger 3S or similar 4S battery would likely have been more suitable | ||
+ | * Used motors are rated for 2-3S | ||
+ | * Lack of BEC causes one ESC to heat up far too much | ||
+ | * Long frame causes too easily shadows for signals | ||
+ | |||
+ | ===== The Plan ===== | ||
+ | {{: |