rc:blackout-super-mini-h-quad
This is an old revision of the document!
Blackout Super Mini H Quad
| Specifications | |
|---|---|
| Frame | Blackout Super Mini H (6" arms) |
| FC | Naze32 (Acro), rev 5 |
| Motor | Cobra 2204 2300KV x 4 |
| ESC | KISS ESC 12A x 4 |
| BEC | Pololu D24V10F5, 5V 1A |
| OSD | Micro MinimOSD |
| Prop | GemFan 5x3 x 4 |
| Receiver | FrSky TFR4-B |
| Camera | RunCam 600TVL Mini with 2.8mm lens Mobius with standard lens |
| VTX | ImmersionRC 5.8 GHz 25 mW |
| Antenna | ImmersionRC Circular Polarized SpiroNET v2 |
| Battery | Turnigy nano-tech 3S1P 1400 mAh |
| Weight | 359 g 480 g (with battery) 520 g (with battery & mobius) |
| M2M | 26 cm |
| Flight time | around 6 minutes |
Images
 |  |  |
Videos
- https://www.youtube.com/watch?v=HiOfTqfTJ8k (2015, uncut, first crash)
- https://www.youtube.com/watch?v=notT2aVin40 (2015, with fpv camera view)
- https://www.youtube.com/watch?v=M8SB5OraZF4 (2015, with osd fpv camera view)
Notes
- the nylon screws have a tendency to break even on small impacts, replace with metal screws and let the nylon standoffs act as fuses when needed
- minimize the amount of components tied to the bottom of the top plate for easier maintenance
- don't do a gliding landing on snow
- use bright colored propellers when flying with others to provide better visibility even with fpv
- UART2 (RC3/RC4 pins) needs to be used with OSD serial communication since UART1 (marked RX/TX pins) is shared with the USB port which will not work if OSD is connected to it and powered at the same time
rc/blackout-super-mini-h-quad.1430603236.txt.gz · Last modified: 03.05.2015 00:47 by vergo
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
