Differences

This shows you the differences between two versions of the page.

--- rc:arducopter-like-diy-quadcopter [15.09.2011 19:55]
vergo
+++ rc:arducopter-like-diy-quadcopter [01.08.2013 16:38]
vergo
@@ Line 1: / Line 1: @@
+~~NOTOC~~
+<note important>This quadcopter was dismantled on 1.8.2013 after 21 flights. Using U-shaped motor arms proved to be a mistake due to lack of rigidity. Also the maturity of the ArduPilot software left much to desire. The motors and ESCs will get used in an H-frame quad.</note>
 ====== Arducopter like DIY quadcopter ======
-{{:rc:arducopterlike.jpg?direct&400|}}
+{{ :rc:arducopterlike.jpg?direct&400|}}
-{{:rc:arducopterlike_dark.jpg?direct&400|}}
+^  Specifications  ^^
+| CPU | ArduPilot Mega |
+| IMU | ArduPilot Mega |
+| Motor | RCTimer 2830/13 850KV x 4 |
+| ESC | RCTimer 20A x 4 |
+| Prop | EPP 10x4.5 x 4 |
+| Receiver | FrSky TFR8S |
+| Battery | 3S1P 2650 mAh\\ 3S1P 2200 mAh |
+^ ^^
+| Weight | around 1 kg with battery |
+| M2M | 60 cm |
+===== Videos =====
-  * [[rc:quadcopter-build-cost|Quadcopter build cost]]\\
   * [[http://www.youtube.com/watch?v=t9ZrvL136ng|Test flight with default PID settings]]
   * [[http://www.youtube.com/watch?v=BxJvMroY9CQ|First outdoor flight with onboard camera]]
+===== Lessons learned =====
+  - The collet type prop holders are too often out of balance and vibrations then cause problems
+  - If you plan on flying high then attach some leds for helping seeing the orientation
+  - Watch were the props are when carrying a bigger quadcopter through doorways :-)
+===== Parts used in initial setup =====
+With this setup, the flight time is about 5-6 minutes with 3S 2200mAh and 8-9 minutes with 3S 2650mAh. The prices are somewhat rounded.
+^  item  ^  euro  ^  dollar  ^
+| 3x16 Right Angle Pin Header |  2e  | |
+| Propeller set, 10x4.5 EPP Style, Black (CW + CCW) x 2 |  4e / 8e  | |
+| 4mm plywood (50 x 50 cm) |  6e  | |
+| M3 screws, nuts and misc stuff |  10e  | |
+| aluminium rail 15 x 10 x 1.5 mm |  10e  | |
+| Orthex freezing box 0.3 L (6 pcs) |  6e  | |
+| FrSky TFR8S FASST receiver |  70e  | |
+| ArduPilot Mega CPU board | |  $60  |
+| ArduPilot Mega IMU board, Rev-H, with connectors | |  $160  |
+| RCTimer 2830-13 850KV Outrunner x 4 | |  $10 / $40  |
+| 7.4V -11.1V RC Lipo Battery Low Voltage Alarm | |  $4  |
+| RCTimer 20A ESC x 4 | |  $10 / $40  |
+| TURNIGY BESC Programming Card | |  $7  |
+| Nylon T-Connectors 10 Pairs (20pc) | |  $3  |
+| Reinforced Plastic Undercarriage (Pair) x 2 | |  $1 / $2  |
+| wires of different sizes | |  $6  |
+| 10 cm Servo Lead (Futaba) 32AWG Ultra Light (10pcs) | |  $2  |
+| 10 Pair 3.5mm Male Gold Plated Connector x 2 | |  $4 / $8  |
+| 10 Pair 3.5mm Female Gold Plated Connector x 2 | |  $4 / $8  |
+| Turnigy Battery Strap 330mm | |  $2  |
+^ ^ ^ ^
+| |  112e  |  $342  |
+| |  = ~350e  ||

HumdiWiki

User Tools

Site Tools

Differences

Page Tools