Differences

This shows you the differences between two versions of the page.

--- rc:turnigy-bonsai [30.05.2015 20:03]
vergo
+++ rc:turnigy-bonsai [28.07.2016 02:24]
vergo
@@ Line 5: / Line 5: @@
 ^  Specifications  ^^
 | Motor | T-Motor MT1306 3100KV |
-| ESC | HobbyKing 10A with 1A bec |
+| ESC | <del>HobbyKing 10A with 1A bec</del>\\ HobbyWing FlyFun 10A |
 | Servos | 2 x Hextronik HXT500 |
 | Prop | GemFan 5x3 |
@@ Line 16: / Line 16: @@
 ===== Notes =====
-  - the carbon rods + z bend pieces don't stay well together using only heatshrink
+  * the carbon rods + z bend pieces don't stay well together using only heatshrink
-  - heavier than suggested battery was needed for achieving correct center of gravity
+  * heavier than suggested battery was needed for achieving correct center of gravity
-  - the servos stays well in place even without glue
+  * the servos stays well in place even without glue
-  - battery and receiver compartments are too small by default
+  * battery and receiver compartments are too small by default
-  - hot glue was used during assembly instead of CA
+  * hot glue was used during assembly instead of CA
+  * HobbyKing ESC replaced with HobbyWing ESC on 28.7.2016 to get break support

HumdiWiki