rc:realacc-martian-iv-3-inch-walksnail
This is an old revision of the document!
Not fully tested yet!
Martian IV (3 inch, Walksnail)
| Specifications | |
|---|---|
| Frame | Realacc Martian IV (3 inch) |
| FC+ESC | HGLRC F4 Zeus |
| Motors | RCX H1304 5000KV |
| Props | Emax Avan 3x2.4x3 GemFan 3x1.6x3 |
| Receiver | HappyModel EP1 TCXO (ELRS) |
| Camera | Walksnail Avatar HD Pro Camera |
| VTX | Walksnail Avatar HD Pro |
| Antenna | TrueRC CORE - 45 mm, U.FL, LHCP |
| Battery | Tattu 3S 450 mAh 75C Turnigy nano-tech 3S 850 mAh 45C |
| Weight | 137 g 180 g (with 3S 450 mAh battery) |
| M2M | 14 cm |
| Flight time | ? minutes |
Notes
- See Martian IV (3 inch) for previous notes regarding the frame and FC
- At least Betaflight 4.4.0 is required for Walksnail OSD, 4.5.1 has been used as initially installed version
- While the receiver would fit between the FC and VTX, the VTX gets hot enough during normal operations that it would be a bad place for the receiver which has been placed behind the camera instead
- Walksnail Avatar VTX doesn't have passthrough holes for 20x20 mm stack (or any other for that matter) but long screws from the bottom of the frame have been used instead for mounting leaving decent space below and plenty about the VTX
- Walksnail Avatar HD Pro Kit doesn't come with a camera mount and the hole pattern isn't the same as in RunCam cameras
- The FC doesn't have pads for the beeper resulting in the connector needing to be used for it
Wiring
- Side connector in VTX was used for wiring, pads shown in image just for clarity
- Note that the side connector has different pin order than the pads
rc/realacc-martian-iv-3-inch-walksnail.1722206320.txt.gz · Last modified: 29.07.2024 01:38 by vergo
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
