This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
rc:lantian-l90 [05.05.2019 22:00] vergo |
rc:lantian-l90 [01.06.2019 20:12] vergo |
||
---|---|---|---|
Line 1: | Line 1: | ||
~~NOTOC~~ | ~~NOTOC~~ | ||
+ | |||
+ | < | ||
====== Lantian L90 ====== | ====== Lantian L90 ====== | ||
Line 11: | Line 13: | ||
| Motors | Racerstar Racing Edition 1103 BR1103B 8000KV | | | Motors | Racerstar Racing Edition 1103 BR1103B 8000KV | | ||
| Props | Kingkong 1935 3-Blade Bullnose | | | Props | Kingkong 1935 3-Blade Bullnose | | ||
- | | Receiver | < | + | | Receiver | < |
| Camera | < | | Camera | < | ||
| VTX | Eachine VTX03 | | | VTX | Eachine VTX03 | | ||
Line 33: | Line 35: | ||
- Edges of frame pieces should be sanded to avoid wear in wiring | - Edges of frame pieces should be sanded to avoid wear in wiring | ||
- | - Camera has been mounted with rubber O-rings due to lack of better mount | + | - <del>Camera has been mounted with rubber O-rings due to lack of better mount</ |
- Receiver antenna has been reinforced with a cable tie + heat shrink | - Receiver antenna has been reinforced with a cable tie + heat shrink | ||
- Don't attempt to flash the ESC firmware, 1 of 4 is likely to fail if done via FC, however changing settings is ok | - Don't attempt to flash the ESC firmware, 1 of 4 is likely to fail if done via FC, however changing settings is ok | ||
Line 42: | Line 44: | ||
- Older Kingkong 1935 props have a much tighter center hole which may not always fit the motors and push the shaft out of the motor instead when the prop is inserted | - Older Kingkong 1935 props have a much tighter center hole which may not always fit the motors and push the shaft out of the motor instead when the prop is inserted | ||
* More recent Kingkong 1935 props fix this issue with a slightly larger center hole, those can be identified from the center hub which isn't any longer fully flat | * More recent Kingkong 1935 props fix this issue with a slightly larger center hole, those can be identified from the center hub which isn't any longer fully flat | ||
- | - RunCam Micro Swift 2 will not fit with the default standoffs | + | - RunCam Micro Swift 2 will not fit with the default standoffs |
* With some plastic removal, it's possible to fit the camera using a custom mount while still using the default standoffs and having possibility to get some angle to the camera | * With some plastic removal, it's possible to fit the camera using a custom mount while still using the default standoffs and having possibility to get some angle to the camera | ||
* Only the height is a restricting factor | * Only the height is a restricting factor | ||
+ | - FrSky XM replaced with FrSky XM+ due to [[https:// | ||
===== Wiring ===== | ===== Wiring ===== |