This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
rc:krieger [12.06.2016 14:49] vergo [Wiring] |
rc:krieger [14.06.2016 19:53] vergo |
||
---|---|---|---|
Line 1: | Line 1: | ||
~~NOTOC~~ | ~~NOTOC~~ | ||
- | < | + | ====== Krieger ====== |
{{ : | {{ : | ||
- | |||
- | ====== Krieger ====== | ||
^ Specifications | ^ Specifications | ||
Line 24: | Line 22: | ||
| Weight | 340 g\\ 565 g (with 4S1P 1800 mAh battery) | | | Weight | 340 g\\ 565 g (with 4S1P 1800 mAh battery) | | ||
| M2M | 20 cm | | | M2M | 20 cm | | ||
- | | Flight time | tbd | | + | | Flight time | 6 minutes of cruising |
===== Notes ===== | ===== Notes ===== | ||
Line 37: | Line 35: | ||
* Reversed prop rotation | * Reversed prop rotation | ||
- | * '' | ||
* '' | * '' | ||
* RSSI | * RSSI | ||
Line 46: | Line 43: | ||
* '' | * '' | ||
* '' | * '' | ||
- | * '' | + | * '' |
* Current Sensor | * Current Sensor | ||
* '' | * '' | ||
Line 83: | Line 80: | ||
In Config.h | In Config.h | ||
+ | |||
+ | {{ : | ||
+ | |||
< | < | ||
#define MICROMINIMOSD | #define MICROMINIMOSD | ||
Line 107: | Line 107: | ||
* Corona R4FA-SB provides RSSI as PWM signal but Betaflight 2.8.1 lacks the ability to read the signal if SBUS is enabled, a LC filter connected to the status led was used instead | * Corona R4FA-SB provides RSSI as PWM signal but Betaflight 2.8.1 lacks the ability to read the signal if SBUS is enabled, a LC filter connected to the status led was used instead | ||
* ESCs have been left out from the picture on purpose | * ESCs have been left out from the picture on purpose | ||
+ | * No direct wire soldering to FC was used |