HumdiWiki

User Tools

Site Tools

Trace:
rc:krieger

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision 		Previous revision
Next revision Both sides next revision
rc:krieger [12.06.2016 14:45]
vergo 		rc:krieger [14.06.2016 19:53]
vergo
Line 1: Line 1:
 ~~NOTOC~~ ~~NOTOC~~
  
-<note>build in progress</note>+====== Krieger ======
  
 {{ :rc:files:krieger:krieger.jpg?direct&400|}} {{ :rc:files:krieger:krieger.jpg?direct&400|}}
- 
-====== Krieger ====== 
  
 ^  Specifications  ^^ ^  Specifications  ^^
Line 24: Line 22:
 | Weight | 340 g\\ 565 g (with 4S1P 1800 mAh battery) | | Weight | 340 g\\ 565 g (with 4S1P 1800 mAh battery) |
 | M2M | 20 cm | | M2M | 20 cm |
-| Flight time | tbd |+| Flight time | 6 minutes of cruising |
  
 ===== Notes ===== ===== Notes =====
Line 37: Line 35:
  
   * Reversed prop rotation   * Reversed prop rotation
-    * ''rxrange 2 2000 1000'' 
     * ''set yaw_motor_direction = -1''     * ''set yaw_motor_direction = -1''
   * RSSI   * RSSI
Line 46: Line 43:
     * ''set vbat_scale = 112''     * ''set vbat_scale = 112''
     * ''set vbat_min_cell_voltage = 33''     * ''set vbat_min_cell_voltage = 33''
-    * ''set vbat_warning_cell_voltage = 35''+    * ''set vbat_warning_cell_voltage = 34''
   * Current Sensor   * Current Sensor
     * ''feature CURRENT_METER''     * ''feature CURRENT_METER''
Line 83: Line 80:
  
 In Config.h In Config.h
 +
 +{{ :rc:files:krieger:mwosd_settings.png?direct&300|}}
 +
 <code> <code>
 #define MICROMINIMOSD #define MICROMINIMOSD
Line 99: Line 99:
 ===== Wiring ===== ===== Wiring =====
  
-{{:rc:files:krieger:krieger_wiring.png?direct&400|}}+{{:rc:files:krieger:krieger_wiring.png?direct&550|}}
  
   * The FC image is from an older revision and doesn't have VBAT, RSSI and Current pins visible   * The FC image is from an older revision and doesn't have VBAT, RSSI and Current pins visible
Line 107: Line 107:
   * Corona R4FA-SB provides RSSI as PWM signal but Betaflight 2.8.1 lacks the ability to read the signal if SBUS is enabled, a LC filter connected to the status led was used instead   * Corona R4FA-SB provides RSSI as PWM signal but Betaflight 2.8.1 lacks the ability to read the signal if SBUS is enabled, a LC filter connected to the status led was used instead
   * ESCs have been left out from the picture on purpose   * ESCs have been left out from the picture on purpose
 +  * No direct wire soldering to FC was used
rc/krieger.txt ยท Last modified: 02.07.2018 21:58 by vergo

Page Tools

Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
CC Attribution-Share Alike 4.0 International Donate Powered by PHP Valid HTML5 Valid CSS Driven by DokuWiki