rc:krieger
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
rc:krieger [12.06.2016 13:51] vergo [Betaflight] |
rc:krieger [18.06.2016 00:42] vergo [Krieger] |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ~~NOTOC~~ | ~~NOTOC~~ | ||
| - | < | + | ====== Krieger ====== |
| {{ : | {{ : | ||
| - | |||
| - | ====== Krieger ====== | ||
| ^ Specifications | ^ Specifications | ||
| Line 24: | Line 22: | ||
| | Weight | 340 g\\ 565 g (with 4S1P 1800 mAh battery) | | | Weight | 340 g\\ 565 g (with 4S1P 1800 mAh battery) | | ||
| | M2M | 20 cm | | | M2M | 20 cm | | ||
| - | | Flight time | tbd | | + | | Flight time | 6-7 minutes of cruising\\ 5 minutes of faster flying |
| ===== Notes ===== | ===== Notes ===== | ||
| Line 34: | Line 32: | ||
| ===== Settings ===== | ===== Settings ===== | ||
| - | ==== Betaflight ==== | + | ==== Betaflight |
| * Reversed prop rotation | * Reversed prop rotation | ||
| - | * '' | ||
| * '' | * '' | ||
| * RSSI | * RSSI | ||
| Line 46: | Line 43: | ||
| * '' | * '' | ||
| * '' | * '' | ||
| - | * '' | + | * '' |
| * Current Sensor | * Current Sensor | ||
| * '' | * '' | ||
| * '' | * '' | ||
| - | * '' | + | * '' |
| + | * use 732 for a 45A sensor (or if the board fails to act like a 90A) | ||
| * No beeper when USB is connected | * No beeper when USB is connected | ||
| * '' | * '' | ||
| Line 69: | Line 67: | ||
| * '' | * '' | ||
| * '' | * '' | ||
| - | ==== MWOSD ==== | + | * Onboard flash for blackbox |
| + | * '' | ||
| + | |||
| + | ==== BLHeli (14.6) ==== | ||
| + | |||
| + | * Programming by TX disable | ||
| + | * PWM Frequency / Damped: DampedLight | ||
| + | * Motor Timing: MediumHigh | ||
| + | * Beacon Delay: 5 minutes | ||
| + | * PPM Min Throttle: 1040 | ||
| + | * PPM Max Throttle: 2000 | ||
| + | * Motor Direction Reversed for motors 2 and 3 | ||
| + | |||
| + | ==== MWOSD (1.6) ==== | ||
| In Config.h | In Config.h | ||
| + | |||
| + | {{ : | ||
| + | |||
| < | < | ||
| #define MICROMINIMOSD | #define MICROMINIMOSD | ||
| Line 85: | Line 99: | ||
| #define FC_VOLTAGE_CONFIG | #define FC_VOLTAGE_CONFIG | ||
| </ | </ | ||
| + | |||
| + | ===== Wiring ===== | ||
| + | |||
| + | {{: | ||
| + | |||
| + | * The FC image is from an older revision and doesn' | ||
| + | * The Rctimer Voltage & Current Sensor | ||
| + | * Isn't big enough to work as a PDB, a separate PDB was used | ||
| + | * Has a voltage divider that needs to be bypassed | ||
| + | * Corona R4FA-SB provides RSSI as PWM signal but Betaflight 2.8.1 lacks the ability to read the signal if SBUS is enabled, a LC filter connected to the status led was used instead | ||
| + | * ESCs have been left out from the picture on purpose | ||
| + | * No direct wire soldering to FC was used | ||
rc/krieger.txt · Last modified: 02.07.2018 21:58 by vergo
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
