rc:flex-rc-mini-owl
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision | ||
|
rc:flex-rc-mini-owl [07.09.2016 20:55] vergo [Flex RC Mini Owl] |
rc:flex-rc-mini-owl [19.06.2018 19:34] (current) vergo |
||
|---|---|---|---|
| Line 1: | Line 1: | ||
| ~~NOTOC~~ | ~~NOTOC~~ | ||
| - | < | + | < |
| ====== Flex RC Mini Owl ====== | ====== Flex RC Mini Owl ====== | ||
| + | |||
| + | {{ : | ||
| ^ Specifications | ^ Specifications | ||
| Line 16: | Line 18: | ||
| | Camera | Tarot 520TVL FPV 1/4" | | | Camera | Tarot 520TVL FPV 1/4" | | ||
| | VTX | Hawkeye 5.8GHz 200mW | | | VTX | Hawkeye 5.8GHz 200mW | | ||
| - | | Antenna | Foxeer 5.8G RHCP\\ (mini version) | | + | | Antenna | Foxeer 5.8G RHCP, mini version | |
| - | | Battery | Turnigy nano-tech 450mAh 3S 65C | | + | | Battery | <del>Turnigy nano-tech 450mAh 3S 65C</ |
| ^ ^^ | ^ ^^ | ||
| - | | Weight | 129 g\\ 169 g (with battery) | | + | | Weight | 131 g (without |
| - | | Flight time | ? | | + | | Flight time | around 4 minutes |
| + | |||
| + | ===== Videos ===== | ||
| + | |||
| + | * https:// | ||
| + | * https:// | ||
| ===== Notes ===== | ===== Notes ===== | ||
| Line 42: | Line 49: | ||
| * the buzzer pads marked in inversed polarity | * the buzzer pads marked in inversed polarity | ||
| * the four motor pads may also be in inversed order | * the four motor pads may also be in inversed order | ||
| + | - MWOSD needs to be updated if it shows really have current readings when disarmed. | ||
| + | * The problem is caused by negative current sensor readings. Check scale and offset. | ||
| + | - Turnigy nano-tech 450mAh 3S 65C is the suggested battery by Flex RC. | ||
| + | * Not good in reality, produces low voltage warnings early in flight. | ||
| + | * Use Turnigy nano-tech 850mAh 3S 45C instead, even if a little heavier. | ||
| + | - The field of view of the camera is big enough not to require any uptilt. | ||
| + | - VTX video quality is rather bad even when flown outdoors and doesn' | ||
| ===== Settings ===== | ===== Settings ===== | ||
| - | ==== Betaflight (3.0.0) ==== | + | ==== Betaflight (3.0.0 |
| * Align board | * Align board | ||
| Line 63: | Line 77: | ||
| * the correct value should be around 360-380 due to the value of the resistor | * the correct value should be around 360-380 due to the value of the resistor | ||
| * these appear to give reasonable results at least with low rpm | * these appear to give reasonable results at least with low rpm | ||
| - | * to be verified with full range | + | |
| - | | + | * '' |
| - | * '' | + | |
| - | * something is causing high current to be reported once battery is connected | + | |
| * the configurator is useless for calibration when usb is connected | * the configurator is useless for calibration when usb is connected | ||
| * possibly a flaw in fc design | * possibly a flaw in fc design | ||
| * No beeper when USB is connected | * No beeper when USB is connected | ||
| * '' | * '' | ||
| - | * Rates like to be super | ||
| - | * '' | ||
| * Switches | * Switches | ||
| * AUX1 | * AUX1 | ||
rc/flex-rc-mini-owl.1473270959.txt.gz · Last modified: 07.09.2016 20:55 by vergo
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
