This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
rc:flex-rc-mini-owl [06.09.2016 21:41] vergo |
rc:flex-rc-mini-owl [19.06.2018 19:34] (current) vergo |
||
---|---|---|---|
Line 1: | Line 1: | ||
~~NOTOC~~ | ~~NOTOC~~ | ||
- | < | + | < |
====== Flex RC Mini Owl ====== | ====== Flex RC Mini Owl ====== | ||
+ | |||
+ | {{ : | ||
^ Specifications | ^ Specifications | ||
Line 16: | Line 18: | ||
| Camera | Tarot 520TVL FPV 1/4" | | | Camera | Tarot 520TVL FPV 1/4" | | ||
| VTX | Hawkeye 5.8GHz 200mW | | | VTX | Hawkeye 5.8GHz 200mW | | ||
- | | Antenna | DYS 5.8GHz RHCP\\ (to be replaced with something shorter) | + | | Antenna | Foxeer |
- | | Battery | Turnigy nano-tech 450mAh 3S 65C | | + | | Battery | <del>Turnigy nano-tech 450mAh 3S 65C</ |
^ ^^ | ^ ^^ | ||
- | | Weight | 129 g\\ 169 g (with battery) | | + | | Weight | 131 g (without |
- | | Flight time | ? | | + | | Flight time | around 4 minutes |
+ | |||
+ | ===== Videos ===== | ||
+ | |||
+ | * https:// | ||
+ | * https:// | ||
===== Notes ===== | ===== Notes ===== | ||
Line 42: | Line 49: | ||
* the buzzer pads marked in inversed polarity | * the buzzer pads marked in inversed polarity | ||
* the four motor pads may also be in inversed order | * the four motor pads may also be in inversed order | ||
+ | - MWOSD needs to be updated if it shows really have current readings when disarmed. | ||
+ | * The problem is caused by negative current sensor readings. Check scale and offset. | ||
+ | - Turnigy nano-tech 450mAh 3S 65C is the suggested battery by Flex RC. | ||
+ | * Not good in reality, produces low voltage warnings early in flight. | ||
+ | * Use Turnigy nano-tech 850mAh 3S 45C instead, even if a little heavier. | ||
+ | - The field of view of the camera is big enough not to require any uptilt. | ||
+ | - VTX video quality is rather bad even when flown outdoors and doesn' | ||
===== Settings ===== | ===== Settings ===== | ||
- | ==== Betaflight (3.0.0) ==== | + | ==== Betaflight (3.0.0 |
* Align board | * Align board | ||
Line 62: | Line 76: | ||
* '' | * '' | ||
* the correct value should be around 360-380 due to the value of the resistor | * the correct value should be around 360-380 due to the value of the resistor | ||
- | | + | |
- | * it remains to be tested if correct values are reported if offset | + | * '' |
+ | * '' | ||
+ | * the configurator | ||
* possibly a flaw in fc design | * possibly a flaw in fc design | ||
* No beeper when USB is connected | * No beeper when USB is connected | ||
Line 113: | Line 129: | ||
</ | </ | ||
- | ===== Wiring | + | ===== Wiring ===== |
{{: | {{: |