This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
rc:flex-rc-mini-owl [10.09.2016 02:27] vergo [Notes] |
rc:flex-rc-mini-owl [22.01.2018 23:45] vergo |
||
---|---|---|---|
Line 1: | Line 1: | ||
~~NOTOC~~ | ~~NOTOC~~ | ||
+ | |||
+ | <note important> | ||
====== Flex RC Mini Owl ====== | ====== Flex RC Mini Owl ====== | ||
Line 17: | Line 19: | ||
| VTX | Hawkeye 5.8GHz 200mW | | | VTX | Hawkeye 5.8GHz 200mW | | ||
| Antenna | Foxeer 5.8G RHCP, mini version | | | Antenna | Foxeer 5.8G RHCP, mini version | | ||
- | | Battery | Turnigy nano-tech 450mAh 3S 65C | | + | | Battery | <del>Turnigy nano-tech 450mAh 3S 65C</ |
^ ^^ | ^ ^^ | ||
- | | Weight | 131 g\\ 171 g (with battery) | | + | | Weight | 131 g (without |
- | | Flight time | 2-3 minutes | | + | | Flight time | around 4 minutes | |
+ | |||
+ | ===== Videos ===== | ||
+ | |||
+ | * https:// | ||
+ | * https:// | ||
===== Notes ===== | ===== Notes ===== | ||
Line 44: | Line 51: | ||
- MWOSD needs to be updated if it shows really have current readings when disarmed. | - MWOSD needs to be updated if it shows really have current readings when disarmed. | ||
* The problem is caused by negative current sensor readings. Check scale and offset. | * The problem is caused by negative current sensor readings. Check scale and offset. | ||
+ | - Turnigy nano-tech 450mAh 3S 65C is the suggested battery by Flex RC. | ||
+ | * Not good in reality, produces low voltage warnings early in flight. | ||
+ | * Use Turnigy nano-tech 850mAh 3S 45C instead, even if a little heavier. | ||
+ | - The field of view of the camera is big enough not to require any uptilt. | ||
+ | - VTX video quality is rather bad even when flown outdoors and doesn' | ||
===== Settings ===== | ===== Settings ===== | ||
Line 65: | Line 77: | ||
* the correct value should be around 360-380 due to the value of the resistor | * the correct value should be around 360-380 due to the value of the resistor | ||
* these appear to give reasonable results at least with low rpm | * these appear to give reasonable results at least with low rpm | ||
- | * to be verified with full range | + | |
- | | + | * '' |
- | * '' | + | |
- | * something is causing high current to be reported once battery is connected | + | |
* the configurator is useless for calibration when usb is connected | * the configurator is useless for calibration when usb is connected | ||
* possibly a flaw in fc design | * possibly a flaw in fc design |