rc:diy-h-frame-fpv-quadcopter
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Last revision Both sides next revision | ||
|
rc:diy-h-frame-fpv-quadcopter [12.06.2016 16:15] vergo [Notes] |
rc:diy-h-frame-fpv-quadcopter [12.06.2016 17:06] vergo |
||
|---|---|---|---|
| Line 3: | Line 3: | ||
| ====== DIY H-Frame FPV Quadcopter ====== | ====== DIY H-Frame FPV Quadcopter ====== | ||
| - | {{ : | + | {{ : |
| ^ Specifications | ^ Specifications | ||
| - | | Frame | DIY | | + | | Frame | DIY (Plywood frame + square aluminium arms) | |
| | FC | Naze32 (full), rev 5 | | | FC | Naze32 (full), rev 5 | | ||
| | Motor | T-Motor MT2206-23 1200KV x 4 | | | Motor | T-Motor MT2206-23 1200KV x 4 | | ||
| Line 18: | Line 18: | ||
| | Battery | Turnigy nano-tech 3S1P 2200 mAh | | | Battery | Turnigy nano-tech 3S1P 2200 mAh | | ||
| ^ ^^ | ^ ^^ | ||
| + | | Weight | 530 g\\ 710 g (with battery)\\ 750 g (with battery & mobius) | | ||
| | M2M | 35 cm | | | M2M | 35 cm | | ||
| + | | Flight time | around 6 minutes | | ||
| ===== Notes ===== | ===== Notes ===== | ||
| Line 25: | Line 27: | ||
| * Outdated and heavy design | * Outdated and heavy design | ||
| * Bigger 3S or similar 4S battery would likely have been more suitable | * Bigger 3S or similar 4S battery would likely have been more suitable | ||
| + | * Used motors are rated for 2-3S | ||
| * Lack of BEC causes one ESC to heat up far too much | * Lack of BEC causes one ESC to heat up far too much | ||
| * Long frame causes too easily shadows for signals | * Long frame causes too easily shadows for signals | ||
| + | |||
| + | ===== The Plan ===== | ||
| + | |||
| + | {{: | ||
rc/diy-h-frame-fpv-quadcopter.txt ยท Last modified: 19.06.2016 13:16 by vergo
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
