AlfaRC Fi-115 (2.5 inch)
| Specifications | |
|---|---|
| Frame | AlfaRC Fi-115 |
| FC+ESC | JHEMCU GHF420AIO |
| RX+VTX | ImmersionRC Ghost Hybrid |
| Antenna | Foxeer 5.8G Micro Lollipop |
| Motors | Happymodel EX1202.5 8000KV |
| Props | Gemfan Hurricane 2512-3 (3-blade, T2.5x1.2x3) |
| Camera | RunCam Racer Nano 2 with 1.8 mm lens |
| Battery | CNHL MiniStar 2S 550 mAh 70-140C HV |
| Weight | 79 g 110 g (with battery) 92g (with RunCam Thumb, without battery) 125g (with RunCam Thumb and battery) |
| M2M | 11.5 cm |
| Flight time | 4-5 minutes |
Videos
- with RunCam Thumb
Notes
- RunCam Racer Nano 2 has far too much edge enhancement and color saturation by default at least when compared to older Swift models causing the image to look abnormal
- Most likely WDR has been the priority with the default settings as there's not much difference between light and shadow
- Edges of frame pieces should be sanded to avoid wear in wiring even if the outer edges have been pre-cut
- The frame comes with plastic standoffs and rather short screws, consider replacing with aluminium standoffs and longer screws
- A shrink wrap has been added over the RX+VTX board to keep the antenna connectors in place even if hit
- This also has the benefit of fingers not touching the board components so easily when handling the frame
- The correct current sensor calibration value is somewhere between 290-300
- ESCs have been updated with Bluejay ESC firmware for getting RPM telemetry
Wiring
- FC+ESC and RX+VTX combinations simplify the wiring and space needed a lot
- The green wire in the provided Ghost Hybrid connector has the RX signal, blue can be removed