This shows you the differences between two versions of the page.
Next revision | Previous revision Last revision Both sides next revision | ||
rc:turnigy-bonsai [30.05.2015 01:45] vergo created |
rc:turnigy-bonsai [28.07.2016 02:23] vergo |
||
---|---|---|---|
Line 5: | Line 5: | ||
^ Specifications | ^ Specifications | ||
| Motor | T-Motor MT1306 3100KV | | | Motor | T-Motor MT1306 3100KV | | ||
- | | ESC | HobbyKing | + | | ESC | <del>HobbyKing |
| Servos | 2 x Hextronik HXT500 | | | Servos | 2 x Hextronik HXT500 | | ||
| Prop | GemFan 5x3 | | | Prop | GemFan 5x3 | | ||
- | | Receiver | FrSky TFR4 | | + | | Receiver | FrSky TFR4-B | |
| Battery | Turnigy nano-tech 2S1P 950 mAh | | | Battery | Turnigy nano-tech 2S1P 950 mAh | | ||
^ ^^ | ^ ^^ | ||
| Weight | 145 g (with battery) | | | Weight | 145 g (with battery) | | ||
- | | Flight time | ? | | + | | Flight time | 6-10 minutes |
===== Notes ===== | ===== Notes ===== | ||
Line 18: | Line 18: | ||
- the carbon rods + z bend pieces don't stay well together using only heatshrink | - the carbon rods + z bend pieces don't stay well together using only heatshrink | ||
- heavier than suggested battery was needed for achieving correct center of gravity | - heavier than suggested battery was needed for achieving correct center of gravity | ||
+ | - the servos stays well in place even without glue | ||
+ | - battery and receiver compartments are too small by default | ||
+ | - hot glue was used during assembly instead of CA | ||
+ | - HobbyKing ESC replaced with HobbyWing ESC on 28.7.2016 to get break support |